Resistive Load Bank 440 kW

Need to know your generator will deliver full power when it counts? Our 440 kW resistive load bank applies a precise, controlled load, so you can test generators, UPS systems and batteries at their full rated output. Load is switched in small steps and held within 2.5% of total capacity. With stainless steel sheathed elements in a 2 mm Zintec steel frame, the unit gives you consistent, repeatable results, test after test.

Testing at full load is often mandatory for new installations and for standby or emergency power supplies. Use this load bank for commissioning activities, carry out routine maintenance testing, or correcting site load. For larger tests, link several units and run them together.

With Aggreko, safety is built into every test. Load can only be applied when the cooling fan is running, and an emergency stop isolates the unit if anything goes wrong.

Resistive Load Bank 440 kW

Features

  • 440 kW of resistive load capacity
  • Load applied in small, individually switched steps
  • Load tolerance within 2.5% of total capacity
  • Stainless steel sheathed elements run well below their temperature limit
  • Frame made from 2 mm Zintec steel welded into one solid body
  • IP54 rated electrical enclosures
  • Vertical discharge through a stainless steel heat shield
  • Load contactors interlocked with the cooling fan
  • Emergency stop, HRC fuses, and thermal overheat detectors
  • Four lifting points and a galvanised forklift pocket base

Loading component...

Loading component...

Loading component...

Loading component...